Miele W 2839I WPM, Руководство по эксплуатации

Страница: 62 / 80

For right hand hinging only
– front panel shown decor side face
down, upper edge at the bottom:
if width ( b ) increases, measurement a
must also be increased
b = 592 mm
N
a = 21.5 mm
b = 593 mm
N
a = 22.0 mm
b = 594 mm
N
a = 22.5 mm
b = 595 mm
N
a = 23.0 mm
b = 596 mm
N
a = 23.5 mm
The height H of the door front panel
corresponds to the door height of the
adjacent units.
C
Drill the two hinge holes (
C
35 mm/
15.5 mm deep) in the back of the
front panel.
D
Next, drill the four smaller holes
(
C
7 mm/10 mm deep) in the back of
the front panel.
E
Shorten the front panel from the
bottom to height
H .
Preparing the fixing points
F
Hold the pre-drilled front panel in the
correct position in front of the
machine door.
G
Mark the fixing points on the back of
the front panel through the holes in
the machine door plate (see arrows
in the illustration).
H
Remove the front panel.
I
Now drill holes (
C
2.5 mm/10 mm
deep) in the back of the front panel.
Installation and connection
62