For SEB 216-3 (see illustration
a
and
c
)
This Electrobrush is easily removed
enabling one of the other accessories
to be used.
^
Press the release button and pull the
suction tube with plug connector out
of the Electrobrush.
The cable will remain on the suction
tube.
Cable
When the Electrobrush is connected to
a cylinder vacuum cleaner, the cable
must be secured to the telescopic tube
and to the suction hose. Nine clips are
supplied for this:
– two for securing the cable to the
telescopic tube (already in position)
– seven for running the cable along the
suction hose (these can be adjusted)
^
Fit the clips to the suction hose
leaving approximately the same
distance between each clip.
Switching on and off
The Electrobrush is operated in
conjunction with the vacuum cleaner.
Some models, however, are fitted with a
switch which allows the Electrobrush to
be switched on and off separately.
Blocked roller warning light
The indicator light on the Electrobrush
has two functions.
The light is
–
yellow
when the Electrobrush is
switched on.
–
red
if the roller brush is blocked, for
example, when a large object has
been vacuumed up.
^
Disconnect the vacuum cleaner from
the electricity supply immediately the
red light comes on. Switch off at the
wall socket and remove the plug.
^
Remove the cause of the obstruction,
see "Cleaning and care".
Then wait for about two minutes, before
switching the cleaner back on again.
This allows the blocked roller warning
indicator to re-set itself.
en
12