Installation surface
A concrete floor is the most suitable in-
stallation surface for a washing machi-
ne, being far less prone to vibration du-
ring the spin cycle than wooden floor-
boards or a carpeted surface.
Please note the following points:
^
The machine must be level and secu-
rely positioned.
^
To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:
^
We recommend a plywood base (at
least 59x52x3 cm). The base should
span several joists and be bolted to
the joists and not only to the floorbo-
ards. Check for the presence of pi-
pes and cables first.
If possible, install the machine in a cor-
ner, as this is usually the most stable
part of the floor.
,
If the machine is installed on a
raised plinth, it
has to be secured
against slippage during spinning
using retaining clips (available from
the Miele Spare Parts Dept).
Transporting the machine to its
installation site
To manoeuvre the machine out of its
packing case to its installation site, hold
it by the front feet as well as by the
edge of the lid where it protrudes to the
rear of the washing machine.
Do not
lift the machine by the drum
door.
,
Ensure that the machine feet and
the floor are dry to prevent the ma-
chine from slipping during the spin
cycle.
Removing the transit fittings
^
To remove the left and right covers
1
. Use a screwdriver to prise out the
cover as illustrated.
2
. Pull the cover forwards to remove.
Installation and connection
43
