Before using for the first time
28
Con@ctivity via a direct WiFi connec-
tion (Con@ctivity 3.0)
Prerequisite: WiFi-enabled Miele
cooker hood
If you do not have a home network, you
can establish a direct connection
between the hob and the cooker hood.
Switch the cooker hood off.
Press and hold the
(
B
*) control.
Press the
(
1
*) control at the same
time.
* Cooker hoods with sensor controls.
2
will light up constantly, and
3
will flash
on and off.
The cooker hood is ready for connec-
tion during the next two minutes.
Switch the hob on.
Touch the 0 sensor control on any of
the numerical displays.
Touch and hold the 0 and 7 sensor
controls on the numerical display at
the same time for 6 seconds.
The seconds can be seen counting
down in the timer display. After the time
has elapsed, a progress light appears
during the connection attempt. If the
connection was successful, the
code
:
appears in the timer display.
If the connection could not be estab-
lished, the timer display will show the
code
:
. Repeat the steps above.
When successfully connected,
2
and
3
will light up constantly on the cooker
hood.
Quit connection mode on the cooker
hood by pressing the run-on con-
trol
.
Con@ctivity has now been activated.
With a direct WiFi connection, it is not
possible to connect the hob and the
cooker hood to a home network. If this
is desired later, the direct WiFi con-
nection between the hob and the
cooker hood must first be reset (see
“Initial commissioning – Con@ctivity”
in the operating and installation in-
structions for the cooker hood. See
“Disconnecting the WiFi”).
Содержание KM 6629-1
Страница 4: ...Contents 4 Electrical connection 77 Product data sheets 80 Conformity declaration 84 ...
Страница 85: ......
Страница 86: ......
Страница 88: ...M Nr 10 975 140 01 en GB KM 6629 1 KM 6639 1 KM 6669 1 KM 6679 1 KM 6699 1 KM 6839 1 KM 6879 1 ...