Miele KM 520, Инструкции по эксплуатации и монтажу

Страница: 30 / 48

Safety instructions for
installation
The appliance must only be installed
and connected to the electricity
supply by a suitably qualified and
competent person in strict
accordance with current national
and local safety regulations.
Fit the wall units and extractor hood
before fitting the hob to avoid
damaging the appliance.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
~
The hob may not be built in over a
fridge, fridge freezer, freezer,
dishwasher, washing machine or
tumble dryer.
~
After installing the hob, ensure that
the connection cable cannot come into
contact with the underside of the
appliance. Make sure that there is no
mechanical obstruction, such as a
drawer, which could damage it.
~
After installing the hob, you need to
make sure that the underside of the
appliance cannot be accessed or
touched. In some cases a front panel
and a protective shelf must be fitted
(see "Protective shelf").
~
Observe carefully the safety
distances given on the following pages.
~
Do not use any sealant except
where expressly instructed to do so.
The sealing strip under the edge of the
top part of the hob provides a sufficient
seal for the worktop (see "Sealant").
All dimensions in this instruction booklet
are given in mm.
Installation
30