Miele KM 500, Инструкции по эксплуатации и монтажу

Страница: 32 / 48

Safety instructions for
installation
Fit the wall units and extractor hood
before fitting the hob to avoid
damaging the appliance.
The veneer or laminate coatings of
worktops (or adjacent kitchen
units) must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
This equipment may only be used
in mobile installations such as
ships, caravans, aircraft etc. if a risk
assessment has been carried out by a
suitably qualified engineer.
The hob may not be built in over a
fridge, fridge freezer, freezer,
dishwasher, washing machine or
tumble dryer.
After installing the hob, ensure that
the connection cable cannot come
into contact with the underside of the
appliance. Make sure that there is no
mechanical obstruction, such as a
drawer, which could damage it.
After installing the hob, you need to
make sure that the underside of the
appliance cannot be accessed or
touched. In some cases a front panel
and a protective shelf must be fitted
(see "Protective shelf").
Observe carefully the safety
distances given on the following
pages.
Do not use any sealant except
where expressly instructed to do
so. The sealing strip under the edge of
the top part of the hob provides a
sufficient seal for the worktop (see
section "Seal").
All dimensions in this instruction booklet
are given in mm.
Installation
32