Miele KF 882 iD-1, Руководство по эксплуатации и установке

Страница: 29 / 44

Repairs to electrical appliances
should only be carried out by a
suitably qualified and competent
person in accordance with local and
national safety regulations.
Unauthorised repairs could be
dangerous.
The following faults can be corrected
without contacting the Miele Service
Department.
What to do if . . .
. . . strange noises can be heard after
switching on the appliance,
especially after it has just been
installed.
^
Check to see whether any pieces of
furniture next to the appliance are
vibrating whilst the appliance is in
operation.
Switch the appliance off then:
^
Check whether the appliance is
aligned correctly.
^
Check whether all parts at the rear of
the appliance are free from
hinderance. Remove any hinderance.
^
Check whether the cable clips were
unclipped from the back of the
appliance before installation. They
could vibrate when the appliance is
operating.
^
Are all removable parts securely
located in the appliance?
^
Are bottles or containers touching
each other?
Remember that the noise of the
compressor and the coolant circulating
in the system is unavoidable.
. . . the appliance does not get cool.
^
Make sure that the temperature dials
are not pointing to the "0" position.
^
Check that the plug is correctly
inserted in the socket.
^
Check that the fuse is not defective
and that the mains fuse has not
blown. If it has contact the Miele Ser-
vice Department.
. . . the door to the freezer section will
not open because it has been opened
and closed too many times in
succession.
^
This is not a fault. The suction caused
by opening and closing the door is
preventing the door from opening.
Wait a few minutes and then try
again. It should now open without
force.
. . . the temperature in the refrigerator
or freezer section is too low.
^
Turn the temperature dial to a setting
closer to "0".
^
The super freeze function has not
been switched off. The indicator light
is still on.
. . . the appliance is switching in too
frequently and for too long.
^
Check whether ventilation gaps in the
plinth and in the housing unit at the
top have been covered over or
become too dusty.
Problem solving guide
29