Miele K 34272 iD, Руководство по эксплуатации

Страница: 62 / 72

^
Check the position of the fixing
bracket at the top and bottom front
edge of the furniture side wall again.
This will create a gap all round of
42 mm to the front edges of the
housing unit side walls.
On furniture with door fittings (e.g.
stubs, seals etc)
the dimension of
these must be taken into account when
making sure there is a gap all round of
42 mm .
^
Pull the appliance forwards by the
dimension of the door fitting to keep
the gap at 42 mm all round.
The hinges and the covers will now
protrude by the dimension of the door
fitting.
Tip: Remove the door fittings. This will
ensure that the door is flush with the
surrounding kitchen unit furniture doors.
Niche height 140 cm and above
^
p
Align the appliance on both sides
by altering the adjustable feet using
the spanner supplied.
If the all round gap of 42 mm is not
maintained between the appliance
casing and the front edge of the
housing unit side walls the door may
not shut properly.
This can cause ice to build up,
condensate to accumulate and lead
to faults in the appliance. These can
all lead to increased energy
consumption.
Securing the appliance in the
niche
^
Press the appliance against the side
of the housing unit on the hinge side.
^
Secure the appliance in the housing
unit by screwing chip board screws
s
through the tabs on the hinges at
the top and bottom of the appliance.
Building in the appliance
62