Miele HS16, Руководство по эксплуатации

Страница: 46 / 136

en
46
Starting the ComfortClean self-clean-
ing function manually (Fig. 30)
If you vacuum a large amount of dust in
one go, you should start the Comfort-
Clean self-cleaning function manually
either during a vacuuming pause or im-
mediately afterwards. This enables the
vacuum cleaner to achieve the very
best cleaning performance again
straight away.
 With the vacuum cleaner switched
on, press the ComfortClean button
for at least 2 seconds.
The vacuum cleaner is switched off
automatically for approx. 20 seconds
and a cleaning process is carried out
which results in operational noise.
The ComfortClean button on the va-
cuum cleaner lights up yellow.
The vacuum cleaner will then switch
back on automatically and will operate
with the previously selected power
level.
We also recommend emptying and
cleaning the fine dust container once or
twice a year (see “Fault resolution” –
“Cleaning the fine dust filter manually”).
Changing the battery in the radio-
control handle (Fig. 31)
Change the battery approximately every
18 months. One 3 V battery (CR 2032)
is required.
The vacuum cleaner can still be used
when the battery has run out or if
there is no battery fitted.
 Switch the vacuum cleaner on using
the On/Off footswitch
 .
The suction power setting  will flash
in the vacuum cleaner display.

Press the ComfortClean button on
the vacuum cleaner for at least four
seconds (Fig. 30).
The vacuum cleaner can continue to be
used in this way, but only at maximum
power.
 Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.

Replace the battery with a new one,
making sure the polarity is correct.
 Replace the cover and tighten the
screw back up again.
 Dispose of the old battery in a muni-
cipal recycling facility.

Keep batteries out of the reach
of children.
A swallowed battery can cause injury
and even death. Even flat batteries
can still be dangerous. If you suspect
a child has swallowed a battery, seek
medical advice immediately*. Exam-
ine devices and make sure the bat-
tery compartment is correctly se-
cured, e.g. that the screw or other
mechanical fastener is tightened. Do
not use if compartment is not secure.
* Australia: Poisons Information
Centre, Tel. 13 11 26;
NZ: National Poisons Centre,
Tel. 0800 764 766
Replacing the thread lifters
(Fig. 32 + 33)
(not possible on EcoTeQ Plus floor-
heads)