Timer - use
Programming hob zone cooking
times
A symbol in the display shows which
hob zone is being programmed.
*
= front left zone
#
= front right zone
t
= both front zones
Make sure the correct symbol is sho-
wing in the display before program-
ming in times.
Turn the hob zone control to the set-
ting required.
The corresponding symbol will flash for
a short time.
Enter the times for the automatic
process (see the relevant Section be-
low).
When a
cooking process has been pre-
selected
the hob zone symbol flashes,
and the time of day is displayed. The
hob control light goes out.
When the process starts running,
the
symbol for the chosen hob zone lights
up.
When the
end of cooking time is re-
ached
– the hob switches off automatically,
– an audible tone sounds for approx. 5
seconds.
– The symbol for the selected hob
zone and the symbol “
)
” both
flash. The symbol “
)
” does not
flash when a cooking end time is en-
tered for the oven.
If the audible tone is not switched off,
as described earlier, it will repeat at 5
minute intervals as a reminder that the
end time has been reached. This
re-
minder
continues for up to an hour.
Both the audible tone and the visual
display can be cancelled by:
– Pressing the “
)
” button.
To use the oven again, the hob zone
selector switch must first of all be
turned to “0".
– Turning the hob zone selector
switch to “0".
28