To programme the water hardness
level
Each time a button is pressed, one of
the indicator lights will flash and light
up in the control panel. However, only
the indicator lights mentioned in the
following programming process stages
are significant.
The programming procedure can be
cancelled at any time by pressing the
Off button
V
. The procedure can
then be re-started from the beginning
again.
^
Switch the dishwasher off using the
Off button
V
.
^
Press the programme selector button
in, and
whilst holding it in
switch
the dishwasher on using the On
button
U
.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the Turbo/Tab button twice.
The Tab indicator light will flash briefly
twice at intervals.
The characters "
p 1
" will flash one after
the other in the display.
This means that the water hardness
level has been set at 1 °d (0.2 mmol/l)
(factory setting).
The value which has been set for the
water hardness is shown as a figure
after the "
p
" in the display (see the
following chart).
Use the programme selector button to
select the value which corresponds to
your water hardness level.
Each press on the button moves you up
a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
^
Switch the dishwasher off with the Off
button
V
.
Before using for the first time
16
Содержание G 1XXX
Страница 74: ...74 ...
Страница 75: ...75 ...
Страница 76: ...Alteration rights reserved G1283 G2283 1608 M Nr 07 066 551 01 ...