Miele Classic G 4205, Техническая информация

Страница: 91 / 159

Technical Information
91
G 5xxx
coarse filter to the microfine filter collect on the filter cap and so cannot block
the drain outlet.
Figure 050-16: Filter Combination in Sump
1 Crown coarse filter
2 Large surface area fine filter, perforation diameter 0.03” (0.8mm)
3 Microfine filter, mesh size 0.01” (0.25mm)
4
Filter cap
2.19 Drain Pump
Drain pump M8 is driven by a synchronous motor and is located under the
cabinet on the left next to the sump. It is directly activated by the electronic. In
case of fault, drain pump M8 can be directly activated via overflow float
switch B8/3. The drain pump pumps the suds via the non-return valve and the
drain hose to the on-site drain.
Drain pump M8 extracts water from below the microfine filter. This reverses
the direction of flow through the microfine filter that normally exists during the
dishwashing cycle. Soil particles that have been trapped in the filter during
dishwashing are then flushed out with the drain water.
Pump capacity:
 Max. 13'1" hose length
 Max. 3'3" head height
Most faults will cause the program in operation to be interrupted and the drain
pump to start.
If the WaterProof System has been activated (
Fault Code F70 , Section 080-3.33),
the drain pump continues to run even after the appliance has been shut off. In this
case, the pump is switched off only when the main power cable is unplugged or by
removing water from the drip pan.
The drain pump of has a rated output of 32W. The flow rate is 6 liters per
minute (3 liters per minute nominal) at 1m pump head height and 4m hose
length. The applied voltage is the nominal rated voltage minus 15% (V
nom
-
15%).