Programming the water hardness
level
Each time a button is pressed, one of
the indicator lights will flash and light
up in the control panel. However, only
the indicator lights mentioned in the
following programming process stages
are significant.
The programming procedure can be
cancelled at any time by pressing the
On/Off button
K
. The procedure can
then be started from the beginning
again.
^
Switch the dishwasher off with the
On/Off button
K
, if it is switched on.
^
Press the Start/Stop button in and
whilst holding it in
switch the
dishwasher on using the On/Off
button
K
.
Keep the Start/Stop button pressed in
until the Start/Stop indicator light
comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the Delay start button twice.
The Delay start indicator will flash
briefly twice at intervals.
The characters "
p 1 5
" will flash one
after the other in the display.
This means that the water hardness
level has been set at 15 °d - German
scale (2.7 mmol/l) (factory setting).
The value which has been set for the
water hardness is shown as a figure
after the "
p
" in the display (see chart).
^
Use the Start/Stop button to select
the value which equates to your
water hardness level.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
^
Switch the dishwasher off using the
On/Off button
K
.
Before using for the first time
21
Содержание 09 276 780
Страница 75: ...75 ...
Страница 76: ...Alteration rights reserved G4420 G4425 5012 M Nr 09 475 890 01 ...