Midwest Industries, Inc.
Ida Grove, IA 51445
800.859.3028
www.shorestation.com
0003853
PAGE 13
09/06/07
HA0024 - Motor Stop
Assembly Instructions
Locate the two motor stop mounting arms (Item #4) and the motor
stop assembly that is pre-assembled at the factory.
Note that the aluminum extrusion in the motor stop assembly has
two holes pre-drilled in one leg of the extrusion. Position the motor
stop assembly so that the drilled leg is to the top as shown. Locate
a 3/8” x 1 ¾” hex bolt and drop it into the hole in the top leg of
the aluminum extrusion. Position the motor stop mounting arm as
shown so that it is on the bottom side of the top leg of the alumi-
num extrusion. Align the hole in the end of the motor stop mounting
arm with the bolt just installed. Insert the bolt through the hole in
the motor stop mounting arm. Secure with a 3/8” flange lock nut.
Tighten. Tap the black plastic caps into the other end of the motor
stop mounting arms.
Repeat step three on the remaining motor stop mounting
arm.
Installation
Locate the two hoist motor stop U-bolt brackets with the
offset (Item #1) and position them as shown in the diagram on the
top side of the hoist platform so they are spaced correctly to fit the
motor stop assembly. The offset must be placed as shown to com-
pensate for the V-shape in the platform.
Place the motor stop assembly on the two hoist motor
stop U-bolt brackets with offset just positioned. Drop the
3/8” x 2 5/8” x 7 ½” U-bolts over the motor stop mounting
arms, then down through the holes provided in the motor
stop U-bolt brackets with the offset.
Push the U-bolts all the way down until the tops of the
U-bolts are resting on the motor stop mounting arms.
Place a straight motor stop U-bolt bracket on the U-bolt
legs on the bottom side of the platform. Secure in place
with 3/8” lock washers and hex nuts. Hand tighten only at
this point.
Repeat steps 5, 6 and 7 on the other motor stop mounting
arm.
Adjustment
Position the hoist motor stop assembly on the hoist so it
is centered side to side on the hoist platform. Changing
the motor stop location front to rear is accomplished by
sliding the straight portion of the motor stop arm through
the U-bolts. This allows you to change the motor stop
location to best position your boat on the hoist. Once the
assembly is in the proper position, tighten the nuts on the
U-bolts.
Содержание ShoreStation SSV60120EAC
