•
28
•
paper feeds from underneath the roll
Chapter 8: Troubleshooting
If you have problems with the display or printer try these troubleshooting suggestions:
Problems with the Display
The display does not turn on:
• Check the connection to the battery.
• The analyzer’s internal batteries may need to be replaced.
The display flickers or is dim:
• The contrast may need to be adjusted in the Utility menu.
• The analyzer’s internal batteries may need to be replaced.
Data will not print
The internal printer will not print
• The analyzer must be connected to the generator battery to print to the internal printer
• The generator battery may be too low to power the printer (battery with at least 11.5 volts)
• Verify that the paper is properly installed
• Verify that the paper sensor is clean and undamaged
Chapter 8: Troubleshooting
Changing the Printer Paper
The IR printer only uses thermal paper in a roll with
the dimensions 2.25 in x 85 ft (57 mm x 25.9 m).
You can purchase replacement rolls at most office
supply stores.
To replace the paper roll:
1. Unlock the printer door by gently pressing on
the red lever. Remove the spent roll.
2. Place a new roll of paper in the compartment,
and pull the paper forward so that it extends past
the serrated edge of the paper slot.
3. Close the door and make sure the lever locks
securely.
release lever: press in this direction
paper
compartment
printer
sensor
