Midtronics ChargeXpress PRO 15, Инструкция по эксплуатации

Страница: 13 / 16

13
CHARGEXPRESS PRO OPERATING STEPS
IMPORTANT NOTES:
Clean the battery terminals. If stud adapters are required, fasten them with the proper tool. Do not
use the battery clamps to tighten adapters.
Use stud adapters on Side-Post and/or Truck batteries that are not in the vehicle.
Never remove the clamps from a battery to abort an active charging session. Always push the
Multi function ON/OFF button shortly before removing the clamps.
Do not leave clamps lying in battery acid.
Clean up any acid spills immediately (e.g., with baking soda and water).
Clamps must be cleaned after every use.
1. CONNECT CHARGEXPRESS PRO TO BATTERY
Connect the CHARGEXPRESS PRO charging clamps to the battery in accordance with all precautions
and safety instructions.
IF YOU ACCIDENTALLY REVERSE THE CLAMP CONNECTIONS, THE CHARGEXPRESS PRO WILL
INDICATE THIS WITH A RED LED AND BLINK RATE (01). SWITCH CHARGER OFF BEFORE
CHANGING CLAMPS.
2. CONNECT TO POWER AC
Plug the CHARGEXPRESS PRO into a dedicated, grounded 16 Amp AC outlet.
Do not use an AC line cord adapter or extension cord.
Switch on the charger.
3. SELECT CHARGEXPRESS PRO MODES
Use the Multi Function ON/OFF button to activate charger and selecting the battery technology used for
charging the battery:
Lead acid, AGM/SPIRAL, GEL, Power supply or Memory Saver
After selecting one of the modes the charger will start charging automatically.
This is indicated by the Orange LED.
CHARGEXPRESS PRO FUNCTIONS
To charge the different battery technologies the CHARGEXPRESS PRO has got a button to select one of
the following:
Battery technology U Boost U Float
Flooded Lead acid; Calcium, Antimony 16,50 / 14,20 Pulse 13,5 – 14,8
AGM / SPIRAL 16,50 / 14,40 Pulse 13,5 – 14,8
GEL 16,50 / 14,30 Pulse 13,5 – 14,8
Power Supply / Memory Saver N/a 13,10