Midtronics ChargeXpress PRO 15, Инструкция по эксплуатации

Страница: 12 / 16

12
CHARGE SEQUENCE
To switch ON the unit, press and hold down one of the Multi function ON/OFF buttons for more then two
seconds. The unit will perform a self-test and the green STATUS LED’s will light up to indicate charger is
ready and OK. In case of a problem the red LED will be lit. This red LED is also used to indicate any
error code in the charger. The LED will blink at a certain rate.
Select a battery technology to ensure that the battery is properly charged. To select any of the 4 positions
press the Multi function ON/OFF button shortly. The top LED (lead-acid) starts blinking. Pushing the Multi
function ON/OFF button again within 4 seconds will scroll to the next selection. This can be continued
until the proper selection is made. When the button is no longer pressed, the LED will turn solid green
indicating that that selection is activated. With the charger clamps connected to a battery the LED will turn
to solid orange and starts charging.
The Multi function ON/OFF button can be pressed at any time during a charge cycle to stop the charger.
Position
1
Lead Acid charge curve
2 AGM / ESPIRAL charge curve
3 GEL charge curve
POWER SUPPLY MODE
Integrated in the charger is also a Power Supply function. This mode ensured that the battery is kept fully
charged during programming of ECU’s or regular vehicle maintenance.
When the charger is not yet switched on, press and hold down one of the Multi function ON/OFF buttons
for more then two seconds. The unit will perform a self-test and the green STATUS LED’s will light up to
indicate charger is ready and OK. In case of a problem the red LED will be lit. This red LED is also used
to indicate any error code in the charger. The LED will blink at a certain rate.
To select the Power Supply Mode press the Multi function ON/OFF button shortly until position 4 is
reached. The LED will now turn to solid green. With the charger clamps connected to a battery the LED
will turn to solid orange to indicate that it is in progress.
Any consumer in the vehicle that needs current will get this from the charger.
Only then, when current is needed in the vehicle the charger will provide this, in any other situation no
current flows.
Position
4
Power Supply Mode