MidNite Solar Hawke's Bay, Руководство пользователя

Страница: 19 / 39

Hawke’s Bay Manual
19| P a g e 1 0 - 4 2 5 - 1 R E V : - F W : X X X
BATTERY
(Figure 17)
•
Connect #2 AWG Batt+ and Batt- cables to the terminal block.
•
If using fine stranded cable, crimp a ferrule onto the cables ends, then insert into the
terminal block and torque. Otherwise, insert bare wire into the terminal block.
•
Torque to 39.8 in-lbs.
ENERGIZING THE HAWKE’S BAY
Read and follow the information below and the procedural steps listed by number to properly
energize and test the charge controller.
Voltmeter – Measure for battery bank voltage between the Hawke’s Bay Battery breaker (at
bottom of breaker) and the Batt- terminal inside the Hawke’s Bay .
o
Battery bank voltage present?
▪
Yes – Good (29-65VDC is good)
▪
No – Check DC wiring to the battery. Check batteries.
•
Close the Hawke’s Bay Battery breaker.
•
Voltmeter – Measure for battery bank voltage between the Hawke’s Bay Batt+ and Batt-
terminals.
o
Battery bank voltage present?
▪
Yes – Good. The Hawke’s Bay will automatically turn on now.
▪
No – Check DC wiring or battery breaker.
•
Depress the Setup button, highlight Battery Config, depress the rotary knob.
Step #2 – Program Hawke’s Bay
TORQUE SPECS
Battery Terminals – 39.8 in-lbs
PV Terminals – 39.8 in-lbs
Ground Terminal - 35 in-lbs
Step #1 – Battery
•
The PV negative from the PV array must be
wired directly into the Hawke’s Bay.
•
Do NOT bond PV negative to ground, the
GF sense circuit will not work.
CAUTION!
Ensure all breakers are OFF ….. You will need a multimeter