9 |
P a g e 1 0 - 3 3 1 - 2 R E V A
MNChinook 200M Instructions
Check the Tip Spacing-
Lay the assembled rotor blade on a flat surface. Using a tape measure or long
steel rule, ensure that the spacing between each tip is equal to within a tolerance of +/-1.5mm. Adjust the
blades as required. Output performance may suffer if the blades are not spaced equally.
Fit the Rotor Blade Assembly-
The assembled and balanced rotor blades can now be fitted to the
Chi-
nook 200M
chassis. This is done by placing the rotor hub plate against the bearing house on the turbine. In
the hardware kit you will find 4 ea M5 X 14mm cap-screws, 4 split lock washers and 4 flat washers. NOTE:
you will have 3 ea. M5 X 16mm cap screws that are for use on the Nose cone. Ensure that all 4 screws are
securely tightened and that the rotor blades are mounted with the flat side of the blades facing forward.
