PRODUCT PROGRAMMING
Midian’s TVS-2-TAIT and VPU-15-TAIT are programmed via Midian’s KL-3 programming cable or using Tait’s
TOPA-EA-007G. Please reference the KL-3 manual for setup instructions of the KL-3 software and hardware.
From the product selection screen on the KL-3 software, select the appropriate product from the list and click OK.
Set the parameters of the scrambler software to fit the application. If any clarifications on a feature are required,
move the mouse cursor over the feature name until the question mark appears and right click, a definition of the
feature will be shown.
After entering the parameters, save the file by going to File - Save As. Enter the file name in the File Name block
and click Save. Saving the file will allow for quick and easy reprogramming of units.
Tait Orca Portable Programming:
KL-3 Programming:
After plugging the board into the radio, but with the radio still open, connect the black lead of
the KL-3 to a common ground and the green clip lead to the Program In hole (P11). Turn power on to the radio
and click “Program Unit” in the KL-3 software.
KL-3 Reading:
It will be necessary to connect the yellow clip lead to the Program Out pad (link 5 – right pad), in
addition to having the green clip lead connected to the Program In hole (P11). Follow the same procedure to read
the unit as for programming, but select “Read Unit” in the menu bar. It is necessary to cycle power after
programming or reading.
Note:
When the scrambler is read, the security codes will be read out as zeroes. If
another scrambler is then cloned with this information, the scramblers will be incompatible because they have
different security codes.
TOPA-EA-007G Programming:
This enables the scrambler to be programmed and read through the radio’s
accessory connector. Plug the TOPA-EA-007G cable into the KL-3’s RJ-11 connector. Connect the TOPA-EA-
007G to the accessory connector of the radio. Turn power on to the radio and click “Program Unit” in the KL-3
software.
Note:
The read function is not available when using the TOPA-EA-007G, as well as programming
tones.
Tait TM-8000 Series Mobile Programming:
KL-3 Programming:
After plugging the board into the radio, but with the radio still open, connect the black lead of
the KL-3 to a common ground and the green clip lead to the Program In hole (P11). Turn power on to the radio
and click “Program Unit” in the KL-3 software.
KL-3 Reading:
It will be necessary to connect the yellow clip lead to the Program Out pad (link 5 – right pad), in
addition to having the green clip lead connected to the Program In hole (P11). Follow the same procedure to read
the unit as for programming, but select “Read Unit” in the menu bar. It is necessary to cycle power after
programming or reading.
Note:
When the scrambler is read, the security codes will be read out as zeroes. If
another scrambler is then cloned with this information, the scramblers will be incompatible because they have
different security codes.
219-03026-0X Programming
: The scrambler may be programmed through the radio using the TM-8000
Encryption Direct Programming Cable (219-03026-0X) available from Tait. Plug the cable into the DB-9 connector
on the EIM. Turn power on to the radio and click “Program Unit” or “Read Unit” in the KL-3 software.
9
