美的
IoT
公司
17
/
18
3.A label with the following statements must be attached to the host end product: This device
contains FCC ID: 2ADQO3U21150Z.
4.To comply with FCC regulations limiting both maximum RF output power and human
exposure to RF radiation, maximum antenna gain (including cable loss) must not exceed:
BT/WIFI: <1dBi
5. This module must not transmit simultaneously with any other antenna or
transmitter
6. The host end product must include a user manual that clearly defines operating
requirements and conditions that must be observed to ensure compliance with current FCC
RF exposure guidelines.
For portable devices, in addition to the conditions 3 through 6 described above, a separate
approval is required to satisfy the SAR requirements of FCC Part 2.1093
If the device is used for other equipment that separate approval is required for all other
operating configurations, including portable configurations with respect to 2.1093 and
different antenna configurations.
For this device, OEM integrators must be provided with labeling instructions of finished
products. Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs:
A certified modular has the option to use a permanently affixed label, or an electronic label.
For a permanently affixed label, the module must be labelled withan FCC ID - Section
2.926 (see 2.2 Certification (labelling requirements) above). The OEM manual must provide
clear instructions explaining to the OEM the labelling requirements,options and OEM user
manual instructions that are required (see next paragraph).
For a host using a certified modular with a standard fixed label, if (1) the module’s FCC ID is
notvisible when installed in the host, or (2) if the host is marketed so that end users do not
havestraightforward commonly used methods for access to remove the module so that the
FCC ID ofthe module is visible; then an additional permanent label referring to the enclosed
module:“Contains Transmitter Module FCC ID:2ADQO3U21150Z” or “Contains FCC ID:
2ADQO3U21150Z” mustbe used. The host OEM user manual must also contain clear
instructions on how end users can find and/or access the module and the FCC ID.