Midea MPPB-14CRN7, Инструкция по эксплуатации

Страница: 41 / 283

Operation
13
FAN operation
-Press the "MODE" button until the"FAN " indicator light comes on.
-Press the "FAN SPEED" button to choose the fan speed. The
temperature can not be adjusted.
-Do not put the duct to window.
SLEEP/ECO operation
-Press this button, the selected temperature will increase(cooling)
or decrease(heating) by 1°C/1°F(or 2°F) 30 minutes.The
temperature will then increase (cooling) or decrease (heating) by
another 1°C/1°F(or 2°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it returns to the
originally selected temperature. This ends the Sleep/Eco mode and
the unit will continue to operate as originally programmed.
NOTE: This feature is unavailabe under FAN or DRY mode.
TIMER operation
-When the unit is on, press the Timer button will initiate the Auto-off stop
program, the TIMER OFF indicator light illuminates. Press the UP or
down button to select the desired time. Press the TIMER button again
within 5 seconds, the Auto-on start program is initiated. And the TIMER
ON indicator light illuminates. Press the up or down button to select the
desired Auto-on start time.
-When the unit is off, press the Timer button to initiate the Auto-on start
program, press it again within five seconds will initiate the Auto-off stop
program.
-Press or hold the UP or DOWN button to change the Auto time by 0.5
hour increments, up to 10 hours, then at 1 hour increments up to 24
hours. The control will count down the time remaining until start.
-The system will automatically revert back to display the previous
temperature setting if there is no operation in a 5 seconds period.
-Turning the unit ON or OFF at any time or adjusting the timer setting to
0.0 will cancel the Auto Start/Stop timer program.
-When the malfunctionoccurs, the Auto Start/Stop timed program will
also be cancelled.
Other features
FOLLOW ME/TEMP SENSING feature(optional)
NOTE:This feature can be activated from the remote control ONLY.
The remote control servesas a remote thermostat allowing for the
precise temperature control at its location. To activate the
Follow Me/Temp Sensing feature, point the remote control towards
the unit and press the Follow Me/Temp Sensing button. The remote
display is actual temperature at its location. The remote control will
send this signal to the air conditioner every 3 minutes interval until
press the Follow Me/Temp Sensing button again. If the unit does
not receive the Follow Me/Temp Sensing signal during any 7
minutes interval, the nit will exit the Follow Me/Temp Sensing mode.
NOTE: This feature is unavailabe under FAN or DRY mode.
EN