10
5. INSTALLATION
1. Never connect the network communication wire with strong power or put it into the
same wiring tube with the strong power. And at least 300-500mm distance should be left
between their wiring tubes.
2. The shield cable must be connected stable to the ground, or transmission may fail.
3. Do not attempt to extend the shield cable by cutting.
4. After finishing connection, do not use Megger to have the insulation check to the
signal wire.
Turn a screwdriver at the concave on bottom panel
of the Wire Controller to remove the Back Cover
When installing the Wire Controller, you
should adjust the bottom of the Wire Controller
Board to the Wire Controller Back Cover which
should be fixed first, then press the other end
of the Wire Controller Board.
When installing the Wire Controller
Cover, be sure there is a hole
in the wall to avoid the Wire
Controller Back Cover being fixed
directly to the wall which is not
allowed for the Wire Joint extrudes
out of the Wire Controller Back
Cover
Wire Controller
Back Cover
Wire Controller
Top Cover
Wire Controller
LCD
Wire Controller
Board
Wire Controller
Bottom Cover
Wood Mounting
Screw (M4X20)
Содержание MD-CCM02/E
Страница 14: ...11 6 TECHNICAL INDEX AND REQUIREMENT EMC and EMI should conform to the requirement of CE Certification...
Страница 15: ...12 Version MDV06U 001IW 202000170150...
Страница 16: ......