19
1)
Loosen the plastic clips
2)
Replace the fan motor, the inverse operation to
complete installation
Damper assembly
None
8.5
Evaporator and temperature sensing system
Evaporator in freezing chamber
1
)
Remove the air duct components in freezing
chamber.
2
)
Disconnect all connectors.
3
)
Remove the welding on inlet and outlet tubes.
4
)
Remove two screws which are used to fix the
evaporator and remove the evaporator.
Components on the evaporator
❶
Fuse
The fuse is located on top of the evaporator
1
)
connect the fuse connector.
2
)
Cut off the band which fixes the fuse.
3
)
Separate the fuse and the evaporator.
*Don’t break the welding of the evaporator in case that
only the fuse needs to be replaced.
❷
Defrost sensor
The defrost sensor is located on top of the evaporator.
1
)
Disconnect the connector of defrost sensor
2
)
Cut off the band which fixes the sensor.
3
)
Separate the sensor and the evaporator.
*Don’t break the welding of the evaporator in case that
only the sensor needs to be replaced.
❸
Defrost heater
The defrost heater is located at bottom of the evaporator.
1
)
Disconnect the connector of defrost heater.
2
)
Cut off the band which fixes the defrost heater.
3
)
Take off the defrost heater from the evaporator.
*Don’t break the welding of the evaporator in case that
only the defrost heater needs to be replaced.
❷
❶
❸
Содержание HS-338FWEN-W
