09
10
Start to Use
You ought to get a good knowledge
of all safety precautions and make
sure that your refrigerator has been
placed properly in its final position
before using.
1. Unpacking
Please install the decorative cover for
bottom beam onto your refrigerator
after unpacking and adjust the front
leveling legs to level your refrigerator.
2. Connecting Your Refrigerator to
the Power Supply
Your refrigerator will enter the ex-
factory default state after connecting
to the power supply and it will display
target temperature for the refrigerator
compartment and freezer
compartment.
3. Work Modes of Your Refrigerator
You can set your refrigerator in either
of the following two ways:
Auto mode:
we suggest you
choosing this mode if you have no
special requirements. Your
refrigerator will work automatically
after you chose this mode.
Manual mode:
You can set the
temperature by pressing the
temperature adjustment key.
4. Put Food into Your Refrigerator
You can put your food into the
refrigerator after a period of time
(About hours in summer) when the
Refrigerator compartment
Though the temperature-adjustable
device could keep most of the
refrigerator compartment at an average
temperature around 2~8 , it fails to
preserve the freshness of food for long.
As a result, the refrigerator
compartment can be used only for
shortterm storage.
Use of turnover beam
Please keep strictly to the warnings on
the label of the turnover beam. It is a
normal phenomenon that the surface
of the turnover beam is hot. Dews on
the surface are also normal in summer
or when the surrounding environment
is wet. What you need to do is to clean
them away with cloth.
Adjustment of cantilever rack
The cantilever rack could be adjusted
to the proper height as required by
food. Please adjust the cantilever rack
by following the arrows as shown in
the diagram. Raise it upward first and
then take it out by tilting it upward.
During installation, put the upper end
of the fixed leg into one of the upper
slots on the supporting iron first and
then put the lower end of the fixed leg
into the third slot on the lower part of
the supporting iron.
Height adjustment and cleaning of
door-mounted bottle rack
Raise the bottle rack in the direction ,
hold it with both hands and take it out
in the direction . After cleaning, you
can install the rack in the reverse order
and you can also adjust the height of
the rack.
refrigerator has already fully
refrigerated its interior compartments.
Tips: The interior temperature may
require a certain period of time to
reach balance if the setting
temperature is changed or other food
is put into the refrigerator. Such a
period of time depends on the change
to the setting temperature, the
surrounding temperature, opening
frequency, the amount of the stored
food and etc.
Adjustment of cantilever rack
Upper end of fixed leg
Lower end of fixed leg
Slot
Adjustment of door-mounted bottle rack
1
2
℃
