Midea FF.567L.SB.ICE, Инструкция по эксплуатации

Страница: 10 / 18

9
Operation and precautions for ice maker
Note
:
Connection of water pipes: please contact the after-sales Service Department of the
Company or professionals to install to avoid any risk.
Warning!
The water pipes must be connected under the condition of power-off. Electric shock may
cause serious injury or death.
Notices!
The water pipe cannot be used where environmental temperature is under 0 , Or it
may lead to freezing.
The water pipe cannot be connected to hot water, which may lead to deformation.
The water pipe should be used in the pressure range 30-100psi.
Lower pressure may cause smaller ice pieces and longer water exiting time.
But higher pressure may damage the filter.
The pipe cannot be connected to drinks, alcohol or other liquids except for water.
1.Turn off the water-tap.
2.Connect water pipe onto the water-tap. The water pipe should be long enough to
prevent the drop-off of the water pipe caused by removing of refrigeratory.
3.Turn off the refrigeratory.
4.Use a connecting pipe to connect the water pipes behind the refrigeratory and on
the water-tap.
5.To prevent the drop-off or leaking of the water pipes, they must be fixed by fixed
pins.
6.Turn on the water tap to check leakage.
7. The refrigeratory is energized an used normally.
<Use of Automatic Ice Maker/ Ice& Water Dispenser>
Notices!
The water pipes are used in the pressure range of 30-100psi.
Water softeners may damage the ice maker and must not be
used.
Please check the ice pieces in the storage box when power-
off above 1h. If the ice pieces are thawing and binding together,
please empty them, because the bound ice pieces may cause
Failure of the ice system.
When the ice pieces in the storage box are binding together, you had better to melt it with
warm water rather than smash and take out them with a sharp tool, which may damage
the refrigeratory.
A. Supply of cold water
1. Choose the ice/water button on the display board, and make sure the water indicator
turns on.
2. When the water switch plate is pressed by the cup, the cold water comes out.
3. When using the refrigeratory the first time, water does not come out before the water
tank in the refrigerator is filled up. The normal manner to get water is pushing and
holding the switch plate for 2-3 minutes.
4. After the water comes out, please discharge water for about 3 minutes to purge the
air and smell of plastic in the water pipe.
5. When cold water is required, it's better to get some ice before getting water.
6. When getting water, it is normal for noise of valve operation.
User shall determine whether to require an anti-reflux valve upon the installation of water
pipe. If required, user shall purchase it individually and install a single-way valve or an anti-
reflux valve on the joint of water route, or make it installed by a specialized person.
Ice maker