Midea ETERNA, Руководство пользователя

Страница: 8 / 24

OPERATING INSTRUCTIONS
7
Airflow direction control
Adjust the air flow direction properly, otherwise it might
cause discomfort or cause uneven room temperatures.
Adjust the horizontal louver using the remote controller.
Adjust the vertical louver manually or using the remote
controller(depending on models).
To set the vertical air flow(Up--Down) direction
Perform this function while the unit is in operation.
Use the remote controller to adjust the air flow
direction. The horizontal louver can be moved at
O
a range of 6 for each press, or swing up and down
automatically. Please refer to the REMOTE
CONTROLLER OPERATION MANUAL for details.
To set the horizontal air flow direction (left - right)
Move the deflector rod manually to adjust the air flow
in the direction you prefer.
IMPORTANT :Do not put your fingers into the panel of
blower and suction side.The high-speed fan inside may
cause danger.
For some models, the vertical louver can be adjusted
by using the remote controller. Please refer to the
REMOTE CONTROLLER OPERATION MANUAL
for details.
,,
,,
,,
,,
Range
Range
Deflector rod
Do not operate the air conditioner for long periods with
the air flow direction set downward in cooling or
dehumidifying mode. Otherwise, condensation may
occur on the surface of the horizontal louver causing
moisture to drop on to the floor or on furnishings.
When the air conditioner is started immediately after it
was stopped, the horizontal louver might not move for
approximately 10 seconds.
Open angle of the horizontal louver should not be set
too small, as COOLING or HEATING performance may
be impaired due to too restricted air flow area.
Do not move the horizontal louver manually, otherwise
the horizontal louver will be out of sync. Please cease
operating, unplug power for a few seconds,then restart
the air conditioner.
CAUTION
NOTE:
Best working conditions(the energy efficiency can be
affected if not set under these conditions):
The best angle of louvers is the default angle of cooling
mode
The best way of setting the angle of louvers at heating
mode is: run the unit for 5 minutes and then use the
remote controller to set the louvers at the default angle
of cooling mode.