24
8. Appendix
Technical & quality requirements for Built-in gas hob
a)
Use of natural gas burner when the burner works 10 minutes in rated power
,
turn it to little fire
and keep 60 seconds
,
reduce the gas pressure to 1400pa
,
the fire shouldn’t extinct.
b)
Neither flame off nor back burning should appear when the flame is in the fire hole of burner.
c)
There should be no cracks and graze in the glass components and china components, besides the
fringe of them.
d)
In Rated gas\rated gas pressure
,
ignite the burner
,
test the time from ignition to burner working
stably
,
it should not be more than 5 seconds.
e)
In Rated gas\rated gas pressure
,
after the burner working for 15 minutes
,
turn off the plug valve
,
then test the time during turning off plug valve and flame-out protection device shutting down
,
it
should be less than 90 seconds.
f)
Every burner should be test ignition
,
fuse transferring time\ flame stabilization
,
ignition\ fuse
transferring time should be less than 5 seconds. Flame-out will be allowed in 5 seconds after
ignition
,
but flame should be stable in 1 minute.
g)
If it may cause security problems after corrosion, electric current and other mental parts should be
corrosion resistance under the normal conditions of use. Live parts and heat insulator should be
prevented to contact with each other unless the heat insulator is corrosion resistance ,
non-hygroscopic and flame-retardant.
h)
The shaft of Knob, handle ,control stick and other similar parts should be electrically neutral unless
the shaft is out of the reach when the other parts are taken down.
i)
The clamp device of ground terminal should be tight enough to avoid accidental loosening. The wire
length from power cord block terminal or cord fixing device to block terminal should be
appropriate .If the flexible cord slips off from the cord block terminal, current carrying conductor
should tighten firstly compared with earth conductor.
j)
Phenomenon that may reflect cooking appliance performance should not appear of the pan support
in normal use.
k)
Gas tightness should be accord with standard request after the gas connection was disassembled five
times.
Содержание 60G SERIES
