Midas LEGEND 3000, Руководство оператора

Страница: 41 / 84

0
+6
0
+6
0
+10
0
+10
phones
monitor
monitor source
mono solo stereo solo
headphones monitor
solo
ADD
CLEAR
MUTE
MUTE
PFL
Monitor Section
The MONO SOLO TRIM adjusts the
incoming solo level before sending it to
the monitor output. The control range is
from +6dB to off with a centre detented
0dB calibration point.
The STEREO SOLO TRIM adjusts the
incoming solo level before sending it to
the monitor output. The control range is
from +6dB to off with a centre detented
0dB calibration point.
The MONO master switch routes the
post fader mono master mix to the mono
local monitor output.
The mono SOLO switch routes solo
signals to the mono local monitor output
when ever a solo is active on the console.
This overrides any signals sent from the
mono master.
The SIS switch routes solo signals to the mono and
stereo local monitor outputs with full left, centre,
right imaging. This overrides any signals sent from
other sources when ever a solo is active on the
console.
The stereo SOLO switch routes solo
signals to the stereo local monitor
outputs when ever a solo is active on the
console. This overrides any signals sent
from the mono master, stereo master or
tape input.
The MONO master switch routes the
post fader mono master mix to the stereo
local monitor outputs.
The ST master switch routes the post
fader stereo master mix to the stereo local
monitor outputs.
The TAPE switch routes the stereo tape
input to the stereo local monitor outputs.
On input channels and stereo returns the
MON switch changes the monitor
signals to be derived from the monitor
signal paths where appropriate. Front of
house signals are monitored as a default.
On outputs the MON changes solos from
stereo pairs to mono.
The LOCAL MONITOR level control
gives continuous adjustment of all three
local monitor output levels from + 10dB
to off.
The local monitor MUTE switch mutes
the local monitor outputs.
The PHONES level control gives
continuous adjustment of the headphone
level from + 10dB to off.
The phones MUTE switch mutes the
headphone outputs.
The SOLO PFL switch sends the mono
PFL solo bus signals to the headphones
and local monitor outputs in place of the
AFL signals. This also changes the solo
meters to monitor PFL solo bus signals.
The SOLO ADD MODE switch allows multiple channel
access to the solo busses. When the solo add mode is off the
action of pressing a solo switch will cancel any previously
active solo. Multiple solos such as stereo left and right
signals can be monitored in this mode of operation as long
as the solo switches are pressed at approximately the same
time. When the solo add mode is on the auto cancelling is
defeated which allows multiple channel or output soloing.
The CLEAR switch is used to clear any
active solos on the console.
31
f.o.h.
input
SOLO SOLO
MON
SIS
MONO MONO
ST
TAPE
output
stereo
mono