Midas HERITAGE 1000, Руководство оператора

Страница: 35 / 66

mute
n-1
aux
lock
a
b
active
system
s-group
vca
1
2
3
4
5
6
7
8
9
10
a
s
s
I
g
n
k
y
e
s
ASSIGN KEYS AND MODE SWITCHES.
The LOCK switch will toggle state each time it is pressed.
When the LOCK switch is illuminated all assignment changes
are disabled and virtual fader operation is locked (either on or
off). The console will automatically revert to a locked state if
no assignment controls are operated within a 90 second period. The N-1 switch (optional) is used in
conjunction with the SET switch on
each input channel to connect the
channel direct outputs to the N-1
summing bus. To indicate N-1 status
any channels that are assigned will
illuminate ALL their ASSIGN LEDS.
The N-1 switch interlocks with the
other mode switches and operates in
much the same way except that the
assign keys are not active.
The VCA, MUTE, GROUP and AUX
switches set the current
assignment/display mode for the input
module assign LED's. As a default
these switches interlock so that only
one mode can be viewed at a time,
however if they are pressed down for
more than 0.5 second the interlock is
removed. This is used for "clear mode"
(see below).
The ASSIGN KEYS are used to
change settings for input VCA,
automute, audio group or aux
assignment in conjunction with the
SET switch on each channel as
follows:-
To enter ASSIGNMENT mode first
press the LOCK switch (to un-lock the
assignment system).
Press the ASSIGN KEYS to set up the
required group number or numbers; a
long press will allow multiple
assignment where as a short press will
clear the previous settings.
Press the SET switch on the input
channels to which the assignment is
required. Again there are two ways to
do this; a long press will remove all
prior settings on the input and replace
them with the new assignment; a short
press will toggle the state of any
switches within the assignment set up.
i.e. if assign keys one and two are on.
Pressing the input SET switch will
cause that channel to toggle the
number one and two assignments for
the channel either from off to on or
visa versa.
To enter CLEAR mode set all the assign keys to off. To do this
simply press the ones that are illuminated which will toggle them
off.
In this mode operating an input SET switch with a long press will
clear all assignments. The mode switches can be used to select
which parts are cleared, i.e. press VCA mode to clear VCA's, press
MUTE mode to clear automutes, or use a long press to activate
more modes for simultaneous clearing.
The A/B switch selects which micro
card is controlling the console
assignment and automation systems.
This is a major function! At the point
of change over there is no defined
control of the faders within the fader
tray and output levels will change. The
A/B switch should there for be treated
with the same cautions used at console
power up/down.
For reliability the assignment and
automation systems are 100%
duplicated. The console can operate on
either of the systems. All snap shots
are stored on BOTH of the systems.
The LED's indicate the status of each
system in the following manner:-
LED green indicates which system
is active
LED off indicates which system is
inactive
LED red indicates that a system is
damaged or not responding and
that a service engineer must
be called as soon as possible.
25