Midas HERITAGE 1000, Руководство оператора

Страница: 18 / 66

bal
+9
-25
+3
-3
0
+12
+18
+15
-6
-9
+6
O O
stereo input
disable
auto
2
8
9
10
4
6
5
1
7
3
10
5
0
5
10
15
20
25
30
40
50
l
C
r
MIDAS HS1004
groups
pan to
s
a
s
I
g
n
masters
masters
to
both
SOLO
SAFE
SET
PAN
MONO
ST
RIGHT LEFT
MUTE
The ST switch connects the post fader
channel signal to the master stereo bus
via the bal control.
The MONO switch connects the post
fader channel signal to the mono
master bus.
The LEFT TO BOTH switch takes the
left input and routes it to all left and
right outputs; cutting the right input
signal.
The RIGHT TO BOTH switch takes
the right input and routes it to all left
and right outputs; cutting the left input
signal. Pressing both of the above
The BALANCE (pan) control is used
to balance the relative levels of the left
and right channel signals that are sent
to the master stereo mix. The control
has a constant power law, i.e. 0dB at
the centre position and + 3dB or off at
either extreme setting.
The PAN to groups switch changes all
group bus assignments to operate via
the stereo balance control. When the
switch is off the group assignments
remain in stereo but without the
balance trim facility.
The MUTE switch mutes the input
channel at all points after the insert
send. The switch can be controlled
from snapshot automation and by
automute scenes.
The recessed AUTOMATION
DISABLE switch sets the module
to a default routing state with all aux
sends ON and all audio group and
VCA group assignments OFF. The
switch is not intended for normal
console operation and it should only
be used in the event of local
automation f a i l u r e .
The SAFE switch removes the entire
input channel from automute and
snapshot automation control.
Assignment of audio and VCA buses
will continue to operate in the normal
way as will VCA master control. This
is particularly useful if a guest artist is
introduced on a channel that would
normally be used for another function.
The METER monitors the peak signal
level of the pre fader input channel.
The FADER gives continuous
adjustment of the input channel level
from +10dB to off.
The ASSIGN LEDs are used to show
the status of the AUX, VCA, MUTE
and AUDIO group assignments. The
central controller MODE switches
toggle through the four available
states.
The SET switch is used to programme
the channel AUX, VCA, MUTE and
AUDIO assignment. The central
controller MODE switches and
ASSIGN keys select the desired
assignment function and the SET
switch toggles the channel on and off
with each alternate press.
The SOLO switch sends the input
channel signal to the PFL mono and
AFL stereo busses. If the switch is
pressed for a short time it will latch on
or off, but, if it is held on for more than
1 second the latching is disabled and
when the switch is released the channel
solo will turn off. As a default the solo
system is auto cancelling so each new
solo cancels the last. The SOLO ADD
mode switch on the master module
defeats the auto cancelling and allows
multiple channel monitoring. In this
mode input solos have priority over
outputs and will temporarily override
any active output solos.
8