MID WEST PRODUCTS HDT-38B, Руководство пользователя и список запасных частей

Страница: 2 / 9

©2017 Mid West Products, Inc. -2- Form No. M1-1603
CONTENTS
ASSEMBLY 2-3
OPERATION 4
GENERAL MAINTENANCE 4
PART LISTING & DRAWINGS 5-7
LONG-TERM STORAGE 8
ORDERING PARTS 8
UNPACKING INSTRUCTIONS:
Remove all Lawn Sweeper Parts, Literature, and
Parts Bag from carton. Open Parts Bag and identify
contents as listed to the right.
Right-hand (R.H.) and Left-hand (L.H.) references
are determined by standing at the rear of the Tractor
or Lawn Sweeper and facing the direction of forward
travel.
Read this Operator's Manual before using the Lawn
Sweeper. You will be able to do a better, safer job.
Key No. Part No. Description Qty.
9 X-1107 5/16-18 Lock Nut 26
15 1-A2936 Dump Rope 1
16 1-A2953 Dump Rope Handle 1
30 L-99 5/16 Flat Washer 2
41 L-80 5/16-18 X 1 HHCS 4
42 L-127 5/16-18 X 1 ½ HHCS 6
43 1-B2829 Hitch Bracket - Center 1
44 1-A2828 Hitch Bracket - Flat 1
63 L-81 5/16-18 X 1 ¼ HHCS 12
65 1-A2901 Hamper Pivot Sleeve 2
67 X-1199 3/8-16 Lock Nut 2
85 X-1358 5/16-18 X 1 ¼ Tube Bolt 2
88 X-1026 3/8-16 X 1 ½ HHCS 2
ASSEMBLY
Assemble Hamper Support Tube and Caster Tubing
to Lawn Sweeper as follows and shown in Figure 1.
A)
Take right and left Caster Tube Assemblies and
attach two Gusset Plates (64) to them using four
Bolts (63) and four Lock Nuts (9). Position
these assemblies on Hamper Support Tube (66)
and attach through holes in Gusset Plates (64)
with four Bolts (63) and four lock Nuts (9). Do
not tighten these Bolts at this time.
B) Position above assembly behind Lawn Sweeper
and attach to Mounting Brackets (75) already
mounted on Lawn Sweeper using four Bolts (42)
and four Lock Nuts (9). Securely tighten all Nuts
in this assembly at this time.
Assemble Debris Hamper and Wind Apron as
follows:
A) Take Hamper Sub-Assembly and place on a flat
surface. Locate five pieces of
¾” diameter
tubing and two Hamper Pivot Brackets (89) as
illustrated in Figure 2 (on the next page).
B)
Insert ends of Rear Tube (91) onto ends of Front
Tube (83) and align holes. Place Hamper Pivot
Brackets (89) with welded brace to the rear over
holes. Insert two Bolts (63) and secure with two
Lock Nuts (9) on each side.
Figure 1