©2019 Mid West Products, Inc.
-2-
Form No. M1-1728
1. Lay all parts on a flat surface, and follow these few
simple instructions.
2. Set Chassis (36) on its Wheels and swing Support
Stand (31) to rear until ends of stand are against stops
in Chassis End Plates. It is not necessary to loosen
Nuts (12). See Figure 3.
3.
Remove Wing Nuts (6) and Hook Bolts (14) from the
Steering Handle (30). Slip reduced ends with holes of
Side Handle Tubes (33) into ends of Steering Handle
Tube (30). Line up hole in each end and reinsert Hook
Bolts (14) through tubes. Secure with Wing Nuts (6).
See Figures 1 and 2 for correct position of all parts.
NOTE: Make certain Hook Bolts point to rear of
sweeper.
4. Now, remove Wing Nuts (6) from the bottom ends of
the Side Handle Tubes (33). Slip bottom ends of Side
Handle Tubes (33) inside Chassis (36) See Figure 8.
Make certain the Thumb Screws (28) go through the
hole in the formed pocket. Reattach the Wing Nuts (6)
onto the Thumb Screws (28) now protruding through
the outside of the Chassis (36).
5. Hang Hamper (35) inside Handle Assembly with rear
Hamper Rod (32) in Hooks (14). Place front Hamper
Rod
(32) in slots “Y” of Chassis End Plates. See
Figures 2 and 4.
Fasten Hangers (5) on Side Handles. Tilt Hanger in
—slide
and twist out over tube. See Figure 6.
All “right” and “left” directions should be considered
as from your position behind the Lawn Sweeper
CHASSIS (36)
(The correct positioning of the Handle Tubes as you are
looking into the Brush Assembly of the Chassis)
FIG. 8
Left Side Handle Right Side Handle
Tube Tube
ASSEMBLY
