Mid-Continent Instrument True Blue Power TB20 Series, Руководство по установке и эксплуатации

Страница: 47 / 48

46 Manual Number 9019286 • Revision E, January 06, 2022
5.9 DO-311A COMPLIANCE QUALIFICATION FORM
MODEL NUMBER: TB20 _ PART NUMBER: 6430020-( )
DESCRIPTION: Advanced Li-Ion Main Ship Battery CERTIFICATION: FAA TSO-179b
MANUFACTURER: True Blue Power, a division of Mid-Continent Instrument Co., Inc.
ADDRESS: 9400 E. 34
th
St. North, Wichita, KS 67226, USA
SPECIFICATION: Test Specification (TS) 713 Test Data Sheet (TDS) 713
STANDARD : RTCA DO-311, Rev A, dated 12/19/2017
SECTION SUB TITLE RESULT SUMMARY
1
1.4 Battery Categories Comply Energy Category 4: >200Wh
Venting Category B: designed vent
Architecture Category: Standalone
2
2.1 General Requirements Comply RTCA/DO-178C, DAL A
Rated Capacity: 20Ah
2.2 Equipment Requirements Comply Met by passing tests in 2.4.4
2.3 Environmental Conditions Pass Required sections of RTCA/DO-160
complete; see EQF
2.4.4
Perform
an
ce
Test
s
2.4.4.1 Physical Examination Pass See IM for physical specifications
2.4.4.2 Acceptance Test Procedure Pass ATP per MPS identified above
2.4.4.3 Insulation Resistance Pass Contacts/case electrically connected
2.4.4.4 Handle Strength Pass Each handle capable of 2X unit weight
2.4.4.5 Capacity Test Pass 20Ah minimum
2.4.4.6 Capacity Test at Low/High
Temp Pass 16.5Ah @ -40°C; 19.5Ah @ 70°C
2.4.4.7 Constant Voltage Discharge Pass I
PP
= 900A, I
PR
= 700A @ 18V
2.4.4.8 Charge Acceptance Pass 18Ah @ -40°C; 19Ah @ 23°C
2.4.4.9 Charge Retention Pass 90% @ 23°C; 80% @ 50°C
2.4.4.10 Cycle Test Pass Retained 99% capacity @ 100 cycles
2.4.4.11 Rapid Discharge Test Pass I
MAX
= 160A @ 70°C
2.4.4.12 Short Circuit with Protection Pass Max current = 2980A; S/C cutoff @
124ms
2.4.4.13 Overdischarge Test Pass Protective circuitry prevented charging
after overdischarge
2.4.4.14 Overcharge Test Pass Overcharge protection activated at 31.5V
2.4.5
Safety
Tes
ts
2.4.5.1 Short Circuit Test of a Cell Pass No release of fragments, flames or
emissions
2.4.5.2 Short Circuit Test of a Battery
without Protection Pass No release of fragments, flames or
emissions
2.4.5.3 Overdischarge without
Protection Pass Emission of gas, smoke and electrolyte
exited vent port
2.4.5.4 Single Cell Thermal Runaway
Containment Test N/A
2.4.5.5 Battery Thermal Runaway
Containment Test Pass All cells achieved thermal runaway;
Maximum case temp = 122°C
2.4.5.6 Explosion Containment Pass No ruptures in case; no emissions
observed
2.4.5.7 Drop Impact N/A
REMARKS:

Compliance includes all of Section 1 and Section 2, unless noted.

Sub-paragraphs without specific criteria of note are not listed.