Routine Operation
3-156
SCM4000
Operator’s Guide/Tech Ref Manual
9.
Press the
SEL
key or Right arrow key and observe the
Recall Preset
option changes to
#X:Preset #X
, as
shown in
, and the
>
cursor changes to a
!
cursor.
Figure 3-449: Recall Preset Option
10.
Press the Up, Down, Left, or Right arrow keys to select
Preset
1
thru
9
, as required, and press the
SEL
key.
11.
Press the
ESC
key repeatedly until the Main Screen is
displayed.
The procedure required to monitor active errors is contained in
the following steps.
1.
Verify the SCM4000 is powered up.
2.
Verify the Main Screen is displayed.
. If the Main Screen is not displayed, press the
ESC
key repeatedly until the Main Screen is
displayed.
Figure 3-450: Main Screen Menu - Typical
3.
Press the Down arrow key, as required, to move the
>>
cursor to the
System Menu
option.
Preset Menu
! #X: Preset #X
Save Settings
SCM4000
>> Modulator
System Menu
4.
Press the
SEL
key or Right arrow key and observe the
System
Menu
.
Figure 3-451: System Menu - Typical
5.
Press the Up or Down arrow keys, as required, to
move the
>>
cursor to the
Active Errors
option.
Note
Error Codes shown in
are typical.
See the
“Troubleshooting” Chapter on page 4-1
for
a complete list of possible SCM4000 Error Codes.
6.
Press the
SEL
key or Right arrow key to select the
Active Errors
option and observe the
Active Errors
menu is displayed.
Figure 3-452: Active Errors Menu - Typical
7.
Press the Up or Down arrow keys to review active
errors (if present).
8.
When active errors (if present) have been reviewed,
press the
ESC
key repeatedly until the Main Screen is
displayed.
System Menu
>> Preset Menu
Active Errors
Error Log
Active Errors
* E333: DCC -12
E332: DCC +12
E122: MPEG PCR
Содержание SCM4000
