Quick Start Guide 3
miriac SBC-LX2160A User Manual
V 1.6
11/71
© MicroSys Electronics GmbH 2021
3.2
Basic Operation
3.2.1 Board Preparation and Power-Up
■
Make sure the switches SW4 and SW5 are set properly in order to select the
correct boot source and board configuration. The board comes preconfigured
to boot correctly on arrival.
■
Connect a mini USB cable to ST29.
■
Connect other peripherals (USB, LAN ...) as intended.
■
Connect the ATX power supply to the PWR connectors ST3 and ST5, while the
ATX power supply is still switched off.
■
Make sure a jumper is placed on ST4 (DCDC_ON) to enable all dc/dc on
carrier
■
Make sure a jumper is placed on ST49 (ON/OFF-switch) to switch the carrier
board ON
■
Enable the ATX power supply via its On/Off switch, located near the AC input.
After Power-up, the green LEDs on the carrier and the module
should light up and the red LEDs should be off.
IF NOT, DISCONNECT THE UNIT FROM POWER AND CHECK
FOR FAULTS!
Figure 3-1 System setup example
