Quick Start Guide 3
miriac SBC-LX2160A User Manual
V 1.6
10/71
© MicroSys Electronics GmbH 2021
3
Quick Start Guide
3.1
Prerequisites
Always make sure to handle the SBC-LX2160A unit ESD-safe!
Otherwise, the unit may suffer permanent damage.
However, do not place the unit directly flat on a metal surface,
as this may result in short circuits and damage to the board.
After unpacking the unit, make sure that is clean and free of visible damage or foreign
objects.
3.1.1 Minimum Required Items
To operate the board, you will at least need the following items:
■
an adequate ATX power supply, delivering 200W minimum.
■
an USB cable (type A
–
mini B) adapted to connector ST29
■
a serial terminal, such as a PC with an USB port running a terminal Software
(e.g. TeraTerm, HyperTerminal, putty, ckermit...), or else a hardware serial
console.
Choose the following parameters:
(a)
115200 Bd
(b)
8 Data bits
(c)
No parity
(d)
1 Stop Bit
3.1.2 Recommended Items
The following items are optional, but strongly recommended for practical operation
and development purposes:
■
Network connection to your local network installation
■
TFTP server available for downloading within the network (Hint: may run on the
same PC as the serial Terminal)
■
SD card as mass storage and/or boot media
