Microsonic TEL8018C, Руководство пользователя

Страница: 39 / 42

17
During the speakerphone operation, the user can adjust the speaker volume level by pressing the
∧
or
∨
key. There are 6 levels of volume selectable.
Note:
If you press key to use earpiece, you can press the
∧
or
∨
key to adjust the earpiece volume,
total 5 levels for selection.
Mute the mouthpiece
During a call, press
MU
key once to mute the mouthpiece and
MUTE
will show on LCD. Press
MU
key again
to get back to the call and the
MUTE
will disappear.
Caller ID – type I & II
¾ TYPE I
After you have applied the caller ID service, you can see the caller party phone number during an incoming
ring.
¾ TYPE II
During the conversation, the phone number of the incoming call of the third party can be seen in the unit.
This function can be worked when the user applied the Telecom service.
Flash (R)
Press
R/C
key to reset the line without leaving the handset.
Pause
Press
RD/P
key will insert a time delay of 3.6 seconds in a dialing sequence.
Pre-dialing
The unit has pre-dialing function, when you may enter and edit the number before dial it out.
The following procedure describes how to use this function
:
1. In idle mode, enter the number you want to dial. During entering, you can press
R/C
key to correct the
number.
2. Press key or key once, the unit will dial out the number show on the LCD.
Redial function
1. Press key or key.
2. Press
RD/P
key, the last dialed number will be dialed again.
Note:
the maximum length of name & number are 12 characters & 20 digits respectively.
Intercom
The intercom feature is activated by pressing the
INT
key.
1. In idle mode, press
INT
key once.
2. The user will be prompted to select the number of the internal handset with which you wish to connect.
3. The destination handset will ring.
Once the call is connected, the display will be shown on both handsets. To end intercom mode, either
handset can hang up the call by press key.
Call transfer
During a call, it’s to transfer the call to another handset.
1. During a phone call, press
INT
key once, you will be prompted to select the number of the internal
handset with which they wish to connect.
2. The destination handset will ring. With the melody defined for an internal call.
3. Press or key of the other handset to accept the call.