Gigabit Ethernet Switch – Hardware Manual
Page 17 of 36
_______________________________________________________________
©2016_MICROSENS GmbH & Co. KG_Küferstr. 16_59067 Hamm/Germany_www.microsens.com
Step3.
Slide the SFP transceiver into the slot until it clicks into place.
NOTE:
SFP transceivers are not provided in the switch
package.
CONNECTING TO A
POWER SOURCE
You can plug or remove power cord from AC power socket, to
switch the power on and off.
Inserting the Power Cord to AC Power Socket
Step1.
Insert the power cable plug directly into the AC Socket located at the back of
the switch.
Step2.
Plug the other end of the cable into a grounded, 3-Pin, AC power source.
Step3.
Check the front-panel LEDs as the device is powered on to be sure the POWER
LED is lit. If not, check that the power cable is correctly plugged in.
WARNING:
For International use, you may need to change the
AC line cord. You must use a line cord set that has been
approved for the socket type in your country.
CONNECTING TO
THE CONSOLE
PORT
The RJ-45 serial port on the switch’s front panel is used to
connect to the switch for out-of-band console configuration. The
command-line-driven configuration program can be accessed
from a terminal or a PC running a terminal emulation program.
The pin assignments used to connect to the serial port are
provided in the following table
