Microscan Vision Hawk Smart Camera, Руководство пользователя

Страница: 96 / 98

Appendix F
Vision HAWK Boot Modes
F-2 Vision HAWK Smart Camera Guide
Diagnostic Boot Mode
The Vision HAWK supports a special boot mode used for diagnostics and
recovery. There are two ways in which the camera can be put into this mode:
1.
This method requires an Ethernet connection between the host PC
and Vision HAWK. Power-on the unit and hold the AutoVISION button
down until the green flash illuminates once. For C-Mount versions,
hold the button down for approximately 30 seconds. The unit is now
configured for IP address 192.168.0.10 with subnet mask
255.255.255.0. Establish a telnet connection between the host PC
and Vision HAWK. The [SAFE-KERNEL] prompt is displayed.
2.
This method requires a QX-1 and a serial connection between the
host PC running a terminal emulator and Vision HAWK camera.
Power-on the unit and hold down the Tab key down for several
seconds. The unit will boot to a [SAFE-KERNEL] prompt with
communication settings of 115200, N, 8, 1 (baud, parity, data bits,
stop bits).
Once the unit is booted, there are many possible actions the user can
take. However, the most useful actions are listed below.
In rare situations, the boot job executed at camera startup can cause
unexpected behavior. If this is the suspected case, it is possible to disable
loading and running of the boot job at startup using the following
command.
[SAFE-KERNEL] BP_UpdateStartupOptions(0, 0)
Note that the loading and running of the boot job is automatically re-enabled
the next time a job is saved to camera flash from AutoVISION or
FrontRunner.
At boot time, the system configures itself using a set of information known
as boot parameters. To obtain a list of the current configuration’s boot
parameters, issue the following command:
[SAFE-KERNEL] BP_Dump()