Another method is to fold the surfaces
back carefully to 90 degrees and then
sand the edges.
Gently press in the gearbox to the
gearbox frame. This is a tight fit so take
your time and work it in slowly.
Glue the gearbox into the gearbox frame
with epoxy glue being careful not to get
aby on the gears.
Also take this opportunity to solder the
extensions onto the motor wires.
Start building the fuselage. Glue in place
the top rear deck as well as the bottom
plate.
NOTE
: The two parts to the bottom of the
picture are not attached yet. These are
the fuselage vertical spacer as well as the
top plate. The Fuselage vertical spacer is
glued in after the wing is inserted and the
top plate is glued in after the radio gear
and servos are set up.
