MICRON RS SERIES
5-WAY NAVIGATION SWITCH
The Micron RS models are controlled entirely by a 5-
way “navigation” switch, which can move in left
,
right
, up
and down
directions and can
also be pushed in the centre
, as follows –
TO SWITCH UNIT ON
Press and release the centre
, of the navigation
switch. The unit will emit a three-tone beep and the
display will illuminate, showing the default editing
screen as follows -
NOTE:
Diagram shown is Micron RS1. RS2 does not
have the centre (vibration) icon shown in the display.
The speaker icon will be flashing initially. If the user
does not touch the navigation switch any further, the
display will clear after approx 10 seconds and the
backlight will go out. The battery level icon will remain,
however, to show that the unit is switched on.
5
U K
4
U K
TO SWITCH UNIT OFF
Press and HOLD DOWN the centre
, of the naviga-
tion switch, for at least 2 seconds. As soon as the
centre is pressed, the display will illuminate (if it was
not illuminated already). After 2 seconds, the back-
light will switch off, the display will clear completely
and the unit will emit a single long, low beep, with a
brief flash of the main LED, indicating that the unit is
switched off.
TO CHANGE SETTINGS
The same procedure is used to change all settings of
the unit –
Firstly, enter the default editing screen by pressing
the navigation switch in any direction . The unit will
emit a “pop” sound and the display will illuminate.
Using
, and
, scroll through to the icon relating
to the setting to be changed. The meanings of the
icons are as follows –
VOLUME ICON
– volume can be adjusted
from 1 (minimum) to 8 (maximum)
TONE ICON
– tone can be adjusted from 1
(lowest tone) to 8 (highest tone)
ROLLERWHEEL SENSITIVITY –
can be adjust-
ed from 1 (minimum) to 8 (maximum)
VIBRATION ICON
– can be adjusted from 1
(off) to 8 (maximum) (Micron RS1 only –
not implemented on RS2)
NIGHTLIGHT BRIGHTNESS
– can be
adjusted from 1 (off) to 8 (maximum)
RANGE TEST ICON
– see later notes
Содержание RS-2
Страница 1: ......