Digital Menu Board 4249 Wall Mount Installation Manual
Page 9
Rev. 04/19
Step 3 –Fastening Temporary Wall Brackets to Wall
Instructions
Diagrams
a)
Determine center point for menu board
on wall. See figure 3A.
1.
Mark wall with centre point
2.
Mark wall with outside
measurements for menu board.
3.
Determine location of wall studs.
Note: Minimum of three (3) studs must
be used to fasten mount to safely
support weight of mount and screens
for wood or steel studded walls.
Fig 3A
•
At either end of the mount placement
mark the outer most studs with the
desired reference height for mount.
•
Using a laser level or other level mark
the desired height on each stud behind.
See figure 3C and 3D.
•
These marks at each stud location will
be used to drill holes for mounting the
Wall Brackets (Part WB).
•
Screws for woods studs included, for
other types of studs appropriate
fasteners required (not included)
Fig. 3C
Fig. 3D
IMPORTANT
All of these Wall Brackets MUST be exactly
at the same height!
•
Attach Wall Brackets to at least 3 studs
for each 2 Wide mount and at least 4
studs for 3 Wide mounts. See figure 3E.
•
Hardware for mounting to wood
supplied.
Fig. 3E
