Digital Menu Board 4249 Wall Mount Installation Manual
Page 11
Rev. 04/19
Step 5 –Tilt Mechanism Adjustment
Instructions
Diagrams
For a 2 wide mount there is a tilt
adjustment mechanism at each end.
For a 3 wide mount there are four (4) tilt
adjustment mechanisms.
The maximum tilt angle is 15 Degrees.
•
To set desired tilt angle, loosen the tilt
adjustment screws using a 4mm Allen
wrench.
•
Once you have the desired tilt angle
tighten the tilt adjustment screws.
Fig. 5A
Step 6 – Attaching End Caps
Instructions
Diagrams
•
Install the Black End Caps on both ends
of mount if not already installed. See
figure 6A and 6B.
•
Use clear silicone (optional) to affix End
Caps.
Fig. 6A Fig. 6B
Tilt adjustment screw
Tilt safety screw.
DO NOT ADJUST
