2
If the device has been exposed to temperature changes, do not switch it on immediately. The arising condensation could
damage the device. Leave the device switched off until it has reached room temperature, and is dry.
This device falls under protection-class I, therefore it is essential that the device be grounded. The electrical connection
must be carried out by a qualified technician.
The device should only be used with rate voltage and frequency. Make sure that the available voltage is not higher than
120V as stated at the end of this manual.
Make sure the power cord is never crimped or damaged in any way, as this could cause shock and damage. If your power
chord is damaged in any way, please purchase a new cable from your local MICROH dealer. Always disconnect power,
when the device is not in use or before cleaning it. Never pull out the plug by tugging the power cord.
During initial start-up, some smoke or smell may arise. This is a normal process, and does not necessarily mean that the
device is defective. It should decrease gradually. Please do not project the beam onto combustible substances.
Fixtures cannot be installed on or near combustible substances. Keep more than 50cm distance from wall for proper
ventilation and air flow. If your fixture is or has become damaged in any way, it shall be exclusively replaced or repaired
by the manufacturer to avoid any hazard.
3. OPERATION INSTRUCTIONS
-
Do not turn on the fixture if it has been through severe temperature differences. Damage may occur to the
fixture. Wait until unit is at room temperature to operate.
-
The unit should be protected from any tremor or agitation during transport.
-
Do not expose the fixture in any excessive heat, moisture or any environment with too much dust when
installing. Do not lay any power cables on the floor. It may cause electronic shock or damage to persons or
equipment.
-
Make sure to attach the safety chain and ensure the screws are properly screwed in when installing the fixture.
-
Make sure the lens is in good condition. It is recommended to replace the unit if there are any damages or
severe scratches.
-
Make sure the fixture is operated and installed by qualified personnel.
-
Keep the original packaging in case of defective product.
-
Any non-manufacturer additions, modifications or changes in any way will void all warranty.
-
Please do not attempt to open unit. It is only to be serviced by an authorized technician. If this occurs, or is
apparent, the warranty will be voided.
