HiLink User manual EN
–
v 1.0.1
35
7.2
C
HARGING
H
I
S
MART
HiSmart is charged with any 5V charger with at least 100mA of power with a USB socket and a USB-A to USB-
C or USB-C to USB-C cable or with an inductive charger (any mobile charger is suitable). Once set charging, the
status LED will light up steady AMBER. When HiSmart is fully charged (full charging takes approximately 2
hours) the light is steady GREEN. If the status LED slowly blinks RED after the device is turned on, the device is
in Low Battery status.
7.3
B
ATTERY LIFE
With a full charge, HiSmart will run for more than 14 hours. Once low battery has been signalled, the device
still has 2 hours of battery life.
7.4
S
LEEP
M
ODE AND
H
ARDWARE
RESET
To perform a HiSmart Hardware reset, with the device turned on, press and hold the middle button until the
status LED, which has turned RED, switches completely off. After doing this, HiSmart goes into a Sleep mode
with very low power consumption (10nA) that preserves the battery.
On the contrary, switching the device off normally will deplete the batteries (if not used) in approximately 2
months.
