Microframe Corporation
Series 3500 - MultiPage System
21
8 AFFINITY PAGER
8.1 SENDING A PAGE
Please see the diagram in the MultiPage
section of this manual for detailed instructions
on sending pages.
8.2 SENDING A GROUP CALL PAGE
All pagers respond to call number “900”
(unless another group call number has been
chosen by the customer and programmed at
the factory). To page all pagers at once, simply
enter “900” and
"SEND."
Then press
"SEND"
again at the beep type prompt.
8.4 CHANGING THE ALERT MODE
Pagers may be programmed to respond to
a page by vibrating, fl ashing lights, fl ashing
and beeping, fl ashing and vibrating, or fl ash-
ing, vibrating and beeping. By default, the
pagers are programmed to fl ash and vibrate
for 8 seconds.
To change the alert mode, follow these
instructions: Remove all the pagers from the
charging unit or unplug the power supply that
is connected to the charging base. Wait for the
demo page to stop (about 7 seconds). Press
"1248" followed by "SEND" and "ENTER." For
the message, enter the code that corresponds
to the alert that you want. (See below.) For
example, if you want the pagers to Flash only,
press "1248-SEND-ENTER-9797-SEND." After
sending the code, the lights on all the pagers
will fl ash to indicate the programming was
received. Return all the pagers to the charg-
ing base or plug the power supply back in. The
pagers are ready to receive the page with the
new alert.
Vibrate Only
"9292"
Flash & Beep
"9595"
Flash & Vibrate
"9696"
Flash Only
"9797"
Flash, Vibrate & Beep
"9898"