Microframe Corporation
Series 3061 - DataTrack Waiter Call
9
2.1 PRE-OPERATION
Prior to operation, check that the Waiter
Call keypad unit has its antenna correctly fitted
and that the 12v power cord is firmly plugged
into the socket provided at the rear of the unit.
The red POWER light on the face panel will
be lit to indicate that the power is connected and
the unit is ready for use. If the light is not on,
check that the lead is plugged into the back of
the unit and the DC power adapter is fitted to a
live wall socket.
Write the names of the servers on the
keypad in the white boxes provided. Only use
approved markers or wax pencils.
Indelible markers will irreparably
damage the surface of the Keypad.
2.2 SENDING A PAGE
To call a Server, briefly press the relevant
button on the Keypad. A red light will come on
at the corner of the button to acknowledge the
button press and confirm that the message has
been transmitted. The light will stay on for
around 30-40 seconds after the key press to
confirm the server has been called. After this
the light will flash for approximately 15 seconds
before extinguishing automatically. This helps
to prevent the Server from being repeatedly
called unnecessarily.
When the pager receives the call, it will
vibrate for a short burst and display the mes-
sage “—1—” to indicate a standard call.
2.3 THE 2x AND 3x BUTTONS
The 2x and 3x keys are programmable for
predefined alpha messages at the time of order,
but is limited to 12 characters.
Press the 2x key and then the Server you
want to send a message. [
PAGING
PAGING
PAGING
PAGING
PAGING
]* will
appear on the Server’s pager. Press the 3x key
and then the Server you want to send a mes-
sage. [
PAGING
PAGING
PAGING
PAGING
PAGING
]* will appear on the Server’s
pager.
*or factory programmed message
2.4 SENDING MULTIPLE PAGES
In the event that you wish to send multiple
calls to different Servers one after the other,
always start with any calls requiring the 3x
prefix. Wait for the 3x light to go out before
sending any calls requiring the 2x prefix. Again,
wait for the 2x light to go out before sending
standard calls.
2.5 TURNING OFF ALL PAGERS
To turn off all pagers from the transmitter,
press the 2x and 3x
SIMULTANEOUSLY
for 3
seconds.
The LED on the 2x and 3x key will turn off
and on. All pagers will turn off.
2 OPERATION
