Microcom 410 ECA, Руководство оператора

Страница: 17 / 82

Chapter 2 Basic
Operation
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
410 ECA Operators Manual 11
2.4.1 NORMAL AND TAG/TEAR MODES
Insert the tag stock under the rear guide shaft, thermally sensitive side up, until it stops. (Note:
The black line sense mark is printed closer to one edge of the label. To assure proper operation, it
is very important that the tags be inserted in the correct direction. Tags inserted backwards will be
printed off center.) Gently push the tags into the printer while turning on the printer. The printer will
advance a few tags and stop. At this point it is recommended that the power be turned off and
back on. This will insure that the printer has detected the black line sense mark correctly. It may
be necessary to slightly lift the printhead to help load the tags.
2.5 CLEANING INSTRUCTIONS
The Microcom 410 ECA printer and printhead should be cleaned approximately every 5,000 tags
or every two weeks whichever occurs first. A Microcom cleaning kit should be used for cleaning
and maintaining a Microcom printer product. It is important to note that the optimum printhead life
is achieved by maintaining a clean printer and printhead.
To clean your Microcom 410 ECA printer:
1) Turn the printer off.
2) Lift the printhead using the "PUSH TO LIFT HEAD" lever and remove any tags that
remains inside the head mechanism.
3) Using the cleaning brush, sweep away all small particles that may be in the area of the
printhead.
4) Moisten a cleaning swab with the cleaning solution and wipe the aluminum peel bar.
5) Moisten the felt side of a cleaning card with the cleaning solution. Insert card with felt side
facing up into the rear of the printer as you would insert tag stock. Hold down on the print
button to feed the card through the printer (see section 2.3). Do not lift the print head for
this operation. Allow the printhead to ride on the cleaning card. Repeat the process if
needed. The cleaning card may be used once at each end.
WARNING: DO NOT TOUCH THE PRINTHEAD WITH ANY METAL OR SHARP OBJECTS