Page 21 of 31. Version 1.03 September 2012
Microbee Premium Plus+ | Construction Manual
unlock it & it springs out. You can insert the card while the self test is still running and then
hold down the reset key for 1 second (you should see the current test running freeze after a
second) and then release the reset key. The Premium Plus should then reset itself, the RED
L.E.D. should flash a number of times & after a few seconds the Microbee SHELL should
appear with the list of files on the ‘disk’. If you get this far,
CONGRATULATIONS,
you have
successfully built your very own Microbee Premium Plus!
The last thing to do of course is to put the casing together.
The baseboard is held into the bottom of the case with a screw & flat washer at either side
of the keyboard frame. The kit was shipped with these screws in place, holding the
keyboard frame. Lastly comes the fitting of the top case. The LEDs on the coreboard show
through the metal badge on the top of the rear top case. These may need aligning with the
slots in the badge and this can be done by bending the leads a little so that the natural
position lines up under the centre of each slot in the badge. Once this is done, the case can
be screwed together. There are six 3mm x 16mm screws that fit in the underside of the
case and screw into the top case sections.
Now your new Microbee Premium Plus is complete.
Enjoy!
